Installing a Brick Paver Walkway or Used Brick

The usage of Bricks or Pavers to produce a sidewalk or patio complements a house in a method that is unrivaled. In addition, installing a Brick or Paver walkway does not always need a pro.

The secret to setting up a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be installed. In addition, string lines must be strung on each side of the sidewalk.
Once the area has been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. The height in between the tamped down sand and the stringline should equate to the density of the brick or paver.

Now that you have a steady base, place a 1" pipe or ledger board the length of the walkway on either side of the pathway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will produce a level surface area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Install an operate on both sides of the ready location. These strips will serve as your sidewalk border and aid to keep the integrity and shape of the pathway. You can get these plastic strip borders at a lot of home enhancement stores. The strips must be anchored down with 12" galvinized nails. You must sink these nails into the ground and through the strips every foot.

The key to laying the bricks/pavers is to read more guarantee that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once again assist keep the stability of the sidewalk.

Inevitably bricks/pavers will require to be cut or divided when developing the pathway. Unless you want to purchase or rent a costly wetsaw, I would suggest purchasing a simple brick/paver splitter. It is essentially a sculpt with a large end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the spot where you want to break the brick. Using a hammer strike the butt end of the sculpt firmly. You might require to do this a couple of times. You may also wish to flip the brick/paver over and strike the other side of the brick using the hammer and chisle. Within a couple of strikes the brick/paver should break easily. If your sidewalk has curves you will require to buy/rent a wetsaw.

After setting up the bricks, build up the outdoors edges with additional sand, and after that shovel in the topsoil and load down strongly.
Spread stone dust over the brand-new pathway and sweep into the fractures. This will complete the interlocking of the bricks and assist to get rid of any weed development.


In addition, installing a Brick or Paver sidewalk does not always require a pro. The key to installing a Brick or Paver Walkway is to first effectively prepare the location where the bricks/pavers are to be set up. Now that you have a steady base, put a 1" pipeline or ledger board the length of the sidewalk on either side of the pathway. These strips will act as your pathway border and assistance to keep the stability and shape of the walkway. Inevitably bricks/pavers will need to be cut or split when building the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *